Rubber Curb Ramp 2 Pack, 12.7 cm Rise Height Heavy-Duty 15 tons Load Capacity Threshold Ramps, Driveway Ramps with Stable Grid Structure for Cars, Wheelchairs, Bikes, Motorcycles

A raised gutter or a lipped garage threshold is a slow tax on a car. You creep at it on an angle, scrape the front bar anyway, and repeat the whole performance every time you come home. A pair of moulded rubber ramps turns that step into a slope you can drive at normally.

Rubber that shrugs off a driveway

Both ramps are moulded from natural rubber, which is what lets them sit in full sun through summer without going soft, and take repeated tyre loads without cracking the way rigid plastic does. There is no chemical stink to them either; the supplier notes only a faint rubber smell. Underneath, a grid structure does the structural work. The open cells compress slightly under a wheel and spread the load across the whole footprint rather than letting it punch through one spot.

What the capacity figure does and does not tell you

The supplier quotes a bearing capacity of up to 15 tons, listed elsewhere in the same source as 33069 lbs. What it does not state is whether that figure applies to a single ramp or to both ramps working together as a pair. Treat it as an unclarified rating rather than a per-ramp guarantee, and get the basis confirmed before putting anything genuinely heavy across it. Rise height is 12.7 cm, which suits a standard kerb or a raised threshold, so measure your step first: a ramp that overshoots the lip is as awkward as no ramp at all.

Seen at night, and staying put

Reflective strips run across the top face, so the ramps show up in a torch beam or under headlights instead of being a black shape you find with a tyre. The tread is textured for grip in the wet, and drainage grooves in the base let water run through rather than pool underneath. Screw grooves are cast in as well: drill and fix through them with expansion screws and the ramps become a permanent fixture rather than something you reposition every week.

Key features

• Sold as a pair: two ramps in the pack.
• Natural rubber moulding: heat and wear resistant, and it does not deform under repeated tyre loads.
• Grid base: compresses and spreads the wheel load, softening the crossing.
• Reflective strips: the ramps stay visible after dark.
• Drainage grooves: water runs through instead of sitting underneath.
• Cast fixing grooves: drill through with expansion screws for a permanent install.

Specifications

• Load capacity: up to 15 tons / 33069 lbs (supplier figure; the source does not state whether this is per ramp or for the pair)
• Rise height: 12.7 cm
• Quantity: 2 ramps
• Material: natural rubber
• Base: grid structure with drainage grooves
• Surface: non-slip texture with reflective strips
• Fixing: cast screw grooves for expansion screws

Before you fit these

• The supplier does not say whether the capacity is per ramp or for the pair. Confirm the basis before crossing with a heavy vehicle or plant.
• Measure the kerb or threshold: these are built for a 12.7 cm rise.
• Expansion screws are referred to as accessories, but pack contents are not itemised in the source. Check before planning a fixed install.
• Fixing anything to a footpath, kerb or shared driveway is normally a matter for your council or body corporate.

Set them down, check the height matches your step, and the daily scrape stops.