- SKU: V1188-TAE41-00600
- VENDOR: 4wdstore.au
Car LED Interior Strip Light 3m USB Neon Wire Lamps Glowing Ambient Lighting Car Decorations Interior Red
Taxes included.
Shipping calculated at checkout.
Guaranteed Safe Checkout
A red glow tracing the dashboard does not stay with the person sitting behind it. After dark it reflects off the inside of the windscreen and carries out of the car, which is the first thing worth thinking about here. The light itself runs from a car USB port at 5 volts, comes as a 3 metre flexible length, and glows red.
The title and the description are describing two different products
This needs saying before anything else about it. The product title calls this an LED interior strip light. The description underneath does not describe an LED strip at all — it describes electroluminescent wire, an inverter-driven technology in which the entire length glows evenly, and it warns outright that an ear held close will pick up a faint buzz. That buzz is the signature of an EL inverter. LED strips do not make it. The description then muddles its own account by signing off with the phrase "electroluminescent LED strip design".
Both versions, published as the supplier gives them:
- Per the product title: LED interior strip light, 3 m USB neon wire, glowing ambient lighting, red.
- Per the product description: flexible electroluminescent (EL) wire, 3 m installed length, 5 V working voltage, USB powered, fuse protected, with an audible hum at close range.
These are not the same thing. EL wire and LED strip differ in brightness, in how evenly they light, in how they degrade with age, and in whether they make any noise at all. Everything below follows the description, because it is by far the more specific of the two accounts. If which technology arrives matters to you — and if a faint buzz in a quiet cabin would bother you, it does — get the seller to confirm before ordering.
The published electrical information, in full
A USB connector that plugs into a car USB port. A working voltage stated as 5 V. Fuse protection, which the supplier says is fitted. That is the entirety of it. No current draw, no wattage and no conductor size appears anywhere in the supplier's material, and none is estimated here — those are precisely the numbers that would tell you whether a particular port can carry it, and they do not exist to quote. If the port you have in mind is already shared with something else, that is a question for the seller rather than a calculation to make from this page.
Red light, and what can be seen from outside the car
Restrictions on the colour of light visible from outside a moving vehicle exist in every Australian state and territory, and red sits among the more tightly handled colours. This is an interior product, but interior light does not stay indoors — it bounces off glass and reaches the road. Nothing on this page states what your state requires, or whether any given installation would satisfy it. Before you run red wire anywhere it can be seen through the windscreen or a side window, confirm the requirements that apply to your vehicle and your state with the authority that enforces them.
Key features
- USB powered at 5 V: plugs into a car USB port, no wiring loom involved.
- 3 m installed length: cuttable, with the supplier noting each new end must be sealed.
- 5 mm sewing edge: the flange the supplier describes for tucking the wire into a gap.
- Fuse protected: stated by the supplier, along with waterproofing and very low running heat.
Specifications
- Technology: electroluminescent wire per the description, LED strip per the title — see above
- Length: 3 m installed
- Sewing edge: 5 mm
- Colour: red
- Working voltage: 5 V
- Power source: USB
- Protection: fuse, per supplier
- Audible noise: the supplier states a faint buzz at close range is normal
- Current draw and conductor size: the supplier publishes neither, and neither is estimated here
Cut it only where you can seal the fresh end afterwards, and site it so the glow bounces off trim rather than firing straight at the glass.
Returns, Refunds and Replacements
Products that are received faulty, damaged, or not as described are eligible for a return, refund, or replacement in accordance with the Australian Consumer Law (ACL). We are committed to ensuring all products meet the standards of quality and reliability expected by our customers. However, please note that we do not accept returns or provide refunds for change of mind. We encourage you to carefully consider your purchase to ensure it meets your needs and expectations.
Delivery Timeframe
Please note that we cannot guarantee the exact date of arrival, and the delivery timeframes (excluding weekends and public holidays) are as follows:
- For customers in Victoria, approximately 7-10 working days;
- For customers in NSW, SA, ACT, and QLD, approximately 9-12 working days;
- For customers in WA, NT, and TAS, approximately 9-12 working days.
Free shipping on orders over $50
Standard delivery within 2–5 business days
Easy 30-day returns
Return items in original condition for a full refund


