Aluminum Ramp 750 LBS Foldable Loading Ramps for Pickup Trucks Bed 1 Piece

One ramp, one bike. Loading a dirt bike into a tray does not need a pair of ramps taking up half the ute. It needs one that is rated for the job, stays put on the tailgate, and folds small enough to ride along afterwards.

Rated for a single machine

The supplier rates this ramp at 750 LBS and sells it as one piece, so there is no ambiguity about pairs or combined figures. The ramp itself weighs 15 LBS, which is the practical difference between alloy and steel: you carry it out to the ute in one hand instead of dragging it. Supplier-listed uses are bikes, motorcycles and other small vehicles, and the source is direct about the limit, asking that the rated capacity not be exceeded.

Nine grids and a two inch section

Section depth is where a ramp gets its stiffness, and this one runs up to 2 in thick with a nine-grid gradient structure inside. Those grids act as internal ribs. Instead of one wide plate flexing under a wheel, the load passes through a series of cells, so deflection stays small and the extrusion does not fold. Welds are finished smooth with no sharp edges left proud, which matters more than it sounds when you are feeding a ramp out of a tray box in the dark.

Folds in a second, stows at 44.5 in

The fold is a single movement on a reinforced triangular joint, open or closed in about a second, with no pins to find and no bolts to lose. Folded, it comes down to 44.5 in (about 113 cm), short enough to stand in a garage corner or lie across a tray without eating the space you need for the load. Rubber-tipped fingers sit over the tailgate or trailer edge, and adjustable safety straps tension the ramp back against the vehicle so it cannot buck or slide as weight comes on.

Key features

• Single ramp: quoted at 750 LBS on its own, with no pair arithmetic involved.
• 15 LBS: light enough to carry and position one-handed.
• Nine-grid gradient structure: internal cells spread the wheel load and limit flex.
• One-second fold: reinforced triangular joint, nothing to assemble.
• Rubber fingers and adjustable straps: keep the top end seated on the tailgate.

Specifications

• Load capacity: 750 LBS (single ramp, per the supplier)
• Weight: 15 LBS
• Folded length: 44.5 in (approx. 113 cm)
• Thickness: up to 2 in
• Structure: nine-grid gradient
• Material: aluminium alloy
• Quantity: 1 ramp

Safe use notes

• The supplier states the 750 LBS capacity should not be exceeded.
• Unfolded length is not published in the source, so measure your tailgate height before ordering.
• Seat the rubber fingers squarely and tension the straps before any weight goes on.
• One ramp suits a single-track machine. Anything on four wheels needs two.

Sensible for bikes, scooters and mowers where a full pair is more ramp than the job needs.