6PCS Black Heavy Duty Fixing Point Anchor Eye Tie Down Lashing Loop D-Ring Hook

Loose gear in the back of a Wrangler ends up wherever the last corner threw it. Factory tie-down points are few, and rarely where you need one. These six D-rings mount to the positions already there and give you somewhere to clip a net or a strap.

Anchor points where the factory left gaps

Each ring swivels through a full circle and holds its angle once tightened, so the loop can be aimed at the load instead of forcing a strap around a corner. Mount them low for a floor net, higher on the rear quarters for bungee cords, a storage bag or a torch holder. The black zinc plating suits where they live: boot floors collect wet gear, sand and salt.

Key features

• Six per pack: enough to net a floor and leave rings for the quarter panels.
• Swivels and locks: rotates to any angle, then stays put once done up.
• Black zinc coating: corrosion resistant, and it disappears against factory trim.
• Uses existing mounts: built around Wrangler factory tie-down positions.

Specifications

• Quantity: 6 per pack
• Material: metal, black zinc coated
• Colour: black
• Rotation: 360 degrees, fixed once tightened
• Placement: rear, upper or lower boot area
• Fitment: Jeep Wrangler JK/JKU 2007-2018; JL/JLU 2018-2019; other vehicles with matching factory tie-down points
• Load rating: not published
• Fixings: not included

What's in the box

• 6 x D-ring tie-down anchor hooks

Check before ordering

• No load rating is published. Use them to restrain cargo, not for recovery, towing or lifting.
• Screws and bolts are not supplied — reuse the factory hardware or source matching fasteners.
• The supplier's JL/JLU listing stops at 2019; later years are not covered.

Measurements are taken by hand and can vary by 1 to 3 cm.