5M Car Interior Lighting,LED Car Interior,5V El Wire LED Light Strip For Car Interior,LED Car Interior Light Wire,Auto

Footwells and door pockets turn into a black hole after dark, and the dome light is too harsh to leave on while driving. A thin strip tucked into a trim gap throws a low, even glow across the cabin, enough to find a phone or a wallet without lighting up the whole interior.

Powered from a USB socket

The strip runs on 5 V and plugs into a USB port, so there is no splicing into the loom and no fuse tap to source. That low voltage is also why the supplier describes it as safe around children. Draw is small enough to share a console port with a phone charger. Plug it in and it lights; unplug it and the whole thing is out again in seconds. The LED beads sit inside the ribbon rather than on top, which is what gives the continuous glow the supplier describes instead of visible hot spots.

Cut and bend it to suit your cabin

Five metres covers more than most cars need, and the ribbon bends around a dash edge, follows a door card seam or loops down a centre console. It cuts to length too, though the supplier notes the fresh end has to be sealed afterwards. Mounting is a push into the gap between the dashboard and the trim panel, where the strip holds itself, or tape, pins or clips on a flat surface.

Key features

• Five metres in one run: a full cabin, with lengths left over.
• USB powered: no wiring work and no fuse tap.
• Cuttable ribbon: trim to length, then seal the cut end.
• Even output: LED beads give a continuous line rather than dots.

Specifications

• Length: 5 m
• Supply: 5 V via USB
• Light source: LED lamp beads (the listing also refers to EL wire material)
• Light spread: 360-degree, as described by the supplier
• Cuttable: yes, cut end must be sealed
• Water resistance: supplier calls the strip material waterproof and the USB device not watertight

What's in the box

• 1 x 5 m car LED light strip
• 1 x USB driver

Before you fit these

• Restrictions apply to the colour of interior lighting that is visible from outside the vehicle while driving, and they vary by state. Confirm the requirements that apply to your vehicle and state before fitting for road use.
• The USB driver is not watertight. Keep it away from water, and route the strip so it stays clear of footwell spills.
• Run the strip and its lead clear of airbag zones, the steering column and the pedals.

The same strip is sold for home and window lighting, so the offcuts rarely go to waste.

Returns, Refunds and Replacements

Products that are received faulty, damaged, or not as described are eligible for a return, refund, or replacement in accordance with the Australian Consumer Law (ACL). We are committed to ensuring all products meet the standards of quality and reliability expected by our customers. However, please note that we do not accept returns or provide refunds for change of mind. We encourage you to carefully consider your purchase to ensure it meets your needs and expectations.

Delivery Timeframe

Please note that we cannot guarantee the exact date of arrival, and the delivery timeframes (excluding weekends and public holidays) are as follows:

• For customers in Victoria, approximately 7-10 working days;
• For customers in NSW, SA, ACT, and QLD, approximately 9-12 working days;
• For customers in WA, NT, and TAS, approximately 9-12 working days.