2pcs Truck Backup Cargo Reversing Light Bulbs

Backing a boat trailer down a ramp after dark on the standard reversing globes is mostly guesswork — a dull orange pool that gives up about a metre behind the towbar. Swapping to LED changes how much of the ground behind you is actually lit, and it happens the instant you select reverse.

Light spread, not a hot spot

The supplier specifies 3030-series LED chips arranged to emit through a full 360 degrees rather than firing in one direction. That matters because a single forward-facing emitter throws a bright centre spot with dark edges, which is the usual complaint about cheap reversing globes. Rated output is 850 lumens per globe, drawn at 7 W on a 12 V supply, at a colour temperature of 7000 K — a cold white with a blue cast rather than the yellow of a filament. Quoted service life is 60,000 hours. All of those are the supplier's figures and are not independently verified.

Alloy body with a decoding chip

LEDs die from heat rather than from hours, so the body is aluminium alloy that pulls warmth out of the chips instead of trapping it behind plastic. A constant-current decoding chip sits inside each globe, holding the current steady so the circuit is not overloaded as things warm up. The supplier lists sealing as IP85, which is not a valid IP code — read it as a general water-resistance claim rather than a defined rating. Each globe measures roughly 4.8 cm long by 1.5 cm across, and the supplier notes measurements are taken by hand and may vary 1-2 cm.

Key features

• 360-degree emission: lights the width of the reversing area rather than one bright patch.
• 7 W draw per globe: low enough to sit on the original reversing circuit.
• Constant-current chip: keeps current steady so the globes do not cook their own circuit.
• Aluminium alloy body: moves heat away from the chips, which is what determines how long an LED lasts.
• Supplied as a pair: enough for both reversing lamps on most vehicles.

Specifications

• Quantity: 2 globes
• LED type: 3030 series, multiple chips per globe
• Light colour: white
• Colour temperature: 7000 K, supplier stated
• Luminous flux: 850 lm, supplier stated
• Power: 7 W
• Voltage: 12 V
• Rated life: 60,000 hours, supplier stated
• Body material: aluminium alloy
• Water resistance: listed by the supplier as IP85 (not a standard IP code)
• Size: approx. 4.8 cm x 1.5 cm x 1.5 cm each
• Globe base / fitment code: not stated by the supplier
• Beam pattern: not stated

What's in the box

• 2 x LED reversing globes

Before you fit these

• The supplier does not publish a base type or fitment code for these globes. Pull one of your existing reversing globes and check the base before ordering, and ask us if you need the fitment confirmed.
• These are LED emitters going into a housing designed around a filament globe. The supplier does not substantiate the resulting beam pattern, so check the spread on a wall before relying on it.
• At 7000 K the output is above the range usually quoted for standard globes. Colour restrictions apply to rear lighting and vary between states — confirm the requirements for your vehicle and state before fitting for road use.
• Some vehicles read the lower current of an LED as a failed globe and will show a warning or flash rate change; a load resistor may be needed.

A straightforward change if the base matches, and worth doing on anything that reverses onto a ramp, a driveway or a work site after dark.

Returns, Refunds and Replacements

Products received faulty, damaged, or not as described are eligible for a return, refund, or replacement in accordance with local consumer laws. We are committed to ensuring all products meet the standards of quality and reliability expected by our customers. Please note that we do not accept returns or provide refunds for change of mind. We encourage you to carefully consider your purchase to ensure it meets your needs and expectations.

Delivery Timeframe

Delivery is approximately 5-10 business days (excluding weekends and public holidays).