10PCS 80W CREE FLOOD LED Work Lights 12V Boat Camping Square 4inch Bar

Kitting out a tray, a trailer and a tinnie usually means buying work lights two at a time and never quite matching the colour. This is a box of ten identical 80 W square lamps, so every mounting point ends up throwing the same light.

Sealed for wash-downs and corrugations

The body is a single-piece die-cast aluminium shell, which matters less for looks than for heat — with no joins, the casting pulls warmth straight off the diodes. Sealing is IP68 and the supplier rates the lamps from -40°C to 80°C for more than 50,000 hours, so a jet from the wash bay or a morning of salt spray shouldn't find a way in. Each lamp sits on a heavy adjustable bracket with a 10 mm screw and an anti-slip nut, which is what keeps the aim where you set it over corrugations.

One colour across the whole fleet

Output is listed at 4800 lumens per lamp at 6000 K, a cold white that reads closer to daylight than the yellow of an old halogen work lamp. That helps when you are picking a dropped spanner out of gravel or judging a reversing line at night. Buying ten as one lot keeps the colour consistent across every position — the thing that usually goes wrong when lamps get replaced one at a time over a few seasons.

Key features

• Ten-lamp set: enough to do a ute, a trailer and a boat in one purchase.
• Die-cast aluminium body: the housing is the heat sink, with no bonded joint to fail.
• Adjustable bracket: 10 mm screw and anti-slip nut to hold aim under vibration.
• 110 mm square footprint: suits bull bar tabs, roll bars, tray rails and gunwales.

Specifications

• Wattage: 80 W (supplier stated; the same listing calls the emitters 3 W chips without giving a count)
• Luminous output: 4800 lm (supplier stated)
• Colour temperature: 6000 K, white
• Beam: supplier lists "spot" with a 60° angle; the title calls it flood
• Voltage: 12 V
• Ingress protection: IP68
• Housing: one-piece die-cast aluminium
• Lens: listed as PC and as PMMA
• Bracket: listed as stainless steel and as galvanised
• Dimensions: 110 x 110 x 30 mm each
• Operating temperature: -40°C to 80°C
• Rated life: over 50,000 hours
• External testing: the supplier states CE

What's in the box

• 10 x square LED work lights
• 10 x mounting brackets with bolts and nuts

Before you fit these

• Auxiliary work and driving lamps are subject to positioning, covering and wiring requirements — confirm what applies to your vehicle and your state before fitting them for road use.
• Add up the load first: at 80 W each, even a few of these sit well beyond a standard accessory circuit. Use a relay, a correctly sized fuse and cable gauge suited to the number you actually run.
• The supplier notes that on-screen colour and hand-measured dimensions may vary slightly from the item.

Sold as a ten-pack for anyone fitting out more than one vehicle or a workshop at once — check your mounting points against the 110 mm footprint before ordering.

NOTE:PO BOX address is not supported, please provide the correct physical address

ATTENTION:
If the customer change their mind and want to cancel the order, please contact us within 2-3 hours after placing the order. Or, once the package is dispatched, we won't be able to intercept packages in transit. Please understand.