HAND TYRE PUMP With Booster & KPA Gauge Psi Bike Air Inflator Bicycle Tire

A soft tyre on a Sunday morning, with the servo shut and the compressor at home, is a small problem that ruins a whole plan. A manual pump asks nothing of a battery or a power point, and it lives in the boot for years without being thought about.

Standing height does the work, not your wrists

At roughly 60 cm tall with a fold-down foot pedal, this is a pump you brace with a foot and drive with your body weight rather than squeeze in your hands. That is the whole reason the height is quoted. Standing over a long barrel lets you push down through the stroke instead of pulling against it, which is what makes the last stretch toward higher pressures possible at all. The pedal folds away flat so the pump still packs down for storage.

Reading the gauge for what it is

A gauge is fitted and the stated pressure range is 0-100 psi. No accuracy figure, tolerance or calibration claim is published anywhere in the source, and none is made here. Treat any gauge built into a hand or floor pump as a guide for getting close, not as a calibrated instrument. For anything that matters — setting road pressures, checking a load-rated tyre, dropping down for sand — confirm the reading with a separate tyre gauge you trust.

Key features

• Fold-down foot pedal: steadies the base so the pump does not walk away mid-stroke.
• Fitted gauge: reads the stated 0-100 psi range as you pump, so you are not guessing.
• Around 60 cm tall: enough barrel length to use your weight instead of arm strength.
• No power needed: works anywhere, with nothing to charge and nothing to fail.

Specifications

• Pressure range: 0-100 psi, exactly as the supplier states it and not converted
• Gauge units: the title refers to a kPa gauge while the specification is given in psi; the source does not confirm which units are marked on the dial
• Gauge accuracy: not published; no tolerance or calibration is claimed
• Height: approximately 60 cm
• Foot pedal: fold-down
• Valve types fitted: not published; the source does not state Schrader, Presta or any adaptor
• Hose length and materials: not published

Before you inflate

• Check the valve type on your own tyres before ordering. Nothing in the source states which valves this pump fits or whether adaptors are supplied.
• Inflate to the pressure on your vehicle's placard or the tyre sidewall, not to the top of the gauge range.
• Verify the final pressure with a separate gauge before driving.

Keep it in the boot and it earns its place the first time something is flat away from home.