2 Pcs Treuil Anneau of Sortie Manuel in Alliage of Aluminum Trou Principal Petits Trous Lateraux, 10mm, 4mm

When a manual awning starts to bind halfway through a wind-out, the fault is almost never the fabric. It is usually the small alloy ring the crank hooks into, chewed out by years of grit and sun. This two-piece set replaces that hardware so the crank engages cleanly again.

Aluminium alloy that lives outdoors

Both pieces are cut from thickened aluminium alloy and finished in a silver baked paint coating. That matters because awning hardware never comes inside — it sits in the weather permanently, and a plain steel eyelet will rust, swell and eventually seize onto the crank. The supplier rates the alloy and its coating against rust, moisture, UV exposure and everyday impact, which is the combination that kills cheap hardware on a coastal patio or a caravan annexe. The internal structure is reinforced so the ring holds its shape rather than opening up under repeated cranking.

Sized to standard crank gear

The title gives two hole sizes: a 10 mm main hole and 4 mm small side holes. Measure your existing ring before ordering, because awning hardware is not standardised across brands and a 1 mm difference is the difference between a clean engagement and a rattle. Fitment is straightforward once the sizes match — the supplier states assembly takes minutes with no specialised tools, which for most people means a screwdriver and a spanner. It suits manual awnings, roller shutter crank systems, pergolas and canopies in common sizes.

Key features

• Two-piece set: replaces the ring and eyelet together, so the crank meets fresh metal on both faces.
• Baked paint finish: a coated surface rather than bare alloy, which slows the chalking you get on sun-facing walls.
• Reinforced body: built to hold its shape under repeated winding instead of deforming.
• No specialised tools: a straight swap for worn hardware on an existing awning.

Specifications

• Material: thickened aluminium alloy
• Finish: silver baked paint coating
• Main hole: 10 mm (per product title)
• Side holes: 4 mm (per product title)
• Quantity: 2 pieces (per product title)
• Application: manual awnings, pergolas, canopies, roller shutter crank systems
• Load rating: none stated by the supplier

Before you fit these

• No load figure is published. The supplier describes the structure as reinforced but gives no capacity in kilograms and names no standard, so treat it as shade hardware only.
• This is not vehicle recovery equipment. Despite where it sits in the catalogue, it is an awning crank component and must never be used as a recovery or towing attachment.
• Recovery attachments must be rated recovery points, and rated points only — never a tow ball, tow bar tongue or bumper.
• Check your hole sizes first. Awning fittings vary between brands and there is no universal pattern.

A cheap fix for an awning that has become a two-person job. Measure the old ring, match the hole sizes, and you are back to one-handed winding.

Returns, Refunds and Replacements

Products that are received faulty, damaged, or not as described are eligible for a return, refund, or replacement in accordance with the Australian Consumer Law (ACL). We are committed to ensuring all products meet the standards of quality and reliability expected by our customers. However, please note that we do not accept returns or provide refunds for change of mind. We encourage you to carefully consider your purchase to ensure it meets your needs and expectations.

Delivery Timeframe

Please note that we cannot guarantee the exact date of arrival, and the delivery timeframes (excluding weekends and public holidays) are as follows:

• For customers in Victoria, approximately 7-10 working days;
• For customers in NSW, SA, ACT, and QLD, approximately 9-12 working days;
• For customers in WA, NT, and TAS, approximately 9-12 working days.