10 Ton Hydraulic Shop Press Workshop Jack Bending Stand H-Frame Tool Stand

Pressing a wheel bearing out with a hammer and a socket is how hubs get wrecked. A press puts the load straight down the centre line, slowly, somewhere you can watch it happen. This is the smaller H-frame in the range, rated by its supplier at 10 Ton, with a bottle jack doing the work by hand.

Where the 125 mm stroke sets the limit

Ram stroke is 125 mm, and that single figure decides more jobs than the tonnage does. It is how far the ram travels in one pass, so anything deeper has to be handled by moving the table rather than pumping further. The table sits on four positions, shifted by hand, which is how you close the gap for a short job and open it up for a long one. Set the workpiece so the ram meets it early in the stroke and the useful travel stays in reserve where you need it.

Hand pump, no air line

The hydraulic side is a manual bottle jack, so nothing needs compressed air or a power point at the bench. Two return springs lift the ram back after each press instead of leaving you to wind it up again. The ram itself is treated and polished, which matters because a scored ram chews through its seal and starts weeping oil. Frame and plates carry a lead-free powder coat, so oil and grease wipe off rather than soaking into the finish.

Key features

• 10 Ton rating: the supplier's stated pressing force for the press.
• Four-position table: moved manually to set working height for the job in hand.
• Twin return springs: lift the ram back between presses.
• Treated and polished ram: a smooth ram is what keeps the seal alive.
• Lead-free powder coat: resists oil, grease and workshop dirt.

Specifications

• Brand: Fiernero
• Model: Shop Press - 10 Ton Hydraulic Standard
• Pressing force: 10 Ton
• Ram stroke: 125 mm
• Working platform: 4 positions
• Frame: heavy-duty steel H-frame
• Hydraulic type: manual bottle jack
• Finish: powder-coated, lead-free paint
• Colour: black
• Weight: 30 kg
• Overall frame dimensions: not published by the supplier

What's in the box

• 1 x hydraulic shop press
• 2 x arbour plates
• 1 x bottle jack
• 1 x handle
• 2 x springs

Before you press anything

• Overall height, width and throat clearance are not published. Measure your space before committing to a 30 kg frame.
• The 10 Ton figure is the supplier's own rating and no test standard is named for it.
• Press work releases parts suddenly. Wear eye protection and keep out of the line of the ram.
• Check every fastener is tight and the jack is seated square before the first press.

A sensible first press for a shed that has outgrown the hammer-and-socket method. Confirm the footprint suits your bench area before ordering.

For returns due to change of mind, a 20% restocking fee will be applied