Giantz Pair 26 LED Tail Lights Stop Reverse Indicator 12V Ute Trailer Truck

Trailer lamps cop the worst of everything: road spray off the tow vehicle, stone chip from the wheels, and a plug that spends half its life in the dirt. When one stops working you hear about it from the car behind. This is a sealed replacement pair, compact enough for a box trailer or ute tray.

Three functions and the number plate in one lamp

Twenty-six emitters per lamp are divided by job: ten red for brake and tail, ten amber for the indicator, and six aimed at the number plate. Building the plate light into the tail lamp removes a separate fitting and a second wire run down the drawbar, which is one of the more common failure points on an older trailer. The body measures 10.5 x 10 x 4.5 cm with 55 mm between the fixing bolts, so it suits a narrow rear rail.

Sealed and ready to bolt on

The housing is ABS with a polycarbonate lens, rated IP68 against dust and water — the rating that earns its keep on a boat trailer reversed into the ramp week after week. No assembly is needed and each lamp comes with a 250 mm tail. The supplier lists 12 V DC operation and identifies only two conductors, leaving the rest undocumented.

Key features

• Sold as a pair: both sides covered in the one purchase.
• Number plate lighting built in: six dedicated emitters per lamp.
• IP68 sealed: ABS body with a polycarbonate lens.
• Bolt-on: 55 mm fixing centres and a 250 mm lead ready to join.

Specifications

• Functions: brake, tail and turn signal, per the supplier's specification
• LED count: 26 per lamp — 10 amber, 10 red, 6 for the number plate
• Dimensions: 10.5 x 10 x 4.5 cm
• Operating voltage: 12 V DC
• Ingress rating: IP68
• Fixing bolt spacing: 55 mm
• Cable length: 250 mm
• Material: ABS and polycarbonate
• Wiring: supplier identifies black as ground and white as the driving lights; remaining conductors not documented
• Assembly required: no
• Lumen output and power draw: not published

What's in the box

• 2 x LED tail lights
• 1 x user manual

Before you fit these

• The product title lists a reverse function. The supplier's specification lists brake, tail and turn signal only and makes no mention of a reverse lamp — check with us before ordering if you need one.
• Only two of the wires are documented. Identify the remainder before connecting anything.
• Supply is listed as 12 V DC. The supplier does not state 24 V compatibility.
• Colour, position and visibility rules for rear lighting differ between states. Confirm the requirements that apply to your vehicle and state before fitting for road use.

A straightforward swap for tired or cracked lamps on a trailer, tray or camper running 12 V.

This product comes with 1 year warranty