Oil Pump Worm Gear Washer Kit Compatible for HUSQVARNA 61 66 266 268 266XP 268XP 272XP

Chain oil still sitting in the tank while the bar runs dry is usually a rounded-off worm gear rather than a blocked feed line. This kit renews the oil pump and the gear that drives it in one go, listed against a specific run of older Husqvarna saws, so the pumping element and its drive are replaced together.

The Husqvarna saws it is listed against

Husqvarna 61, 66, 266, 268, 266XP, 268XP and 272XP. Those seven models are the whole of the published fitment, and nothing wider is claimed for the kit here. All are older professional-class saws, which is exactly why oiler parts on them wear out — decades of resin, sawdust and thickened bar oil grinding through a small drive assembly. The one dimensional figure the supplier gives is a hole spacing of roughly 7 x 4 cm, so hold that against your pump housing before ordering.

Why the drive gear fails before the pump body

The oiler is turned off the crankshaft through a small worm gear, and that gear is deliberately the softest link. It gives way before the crank or the pump does. Symptoms come on gradually: throw-off onto a sheet of paper weakens over a few tanks, the bar rails begin to blue, and the chain stretches faster than it ought to. Renewing the gear on its own often just loads a tired pump, so the pump, gear, needle bearing and washer arrive here as one set.

Key features

• Pump and drive together: oil pump, worm gear, needle bearing and washer in a single kit.
• Seven saws named: the fitment list stops at the Husqvarna models above.
• Iron construction: the only material the supplier states.
• 7 x 4 cm hole spacing: a figure you can measure against your own housing before buying.
• 122 g: the stated weight of the complete set.

Specifications

• Part type: chainsaw oil pump and worm gear kit
• Stated fitment: Husqvarna 61, 66, 266, 268, 266XP, 268XP, 272XP
• Material: iron
• Hole spacing: approx. 7 x 4 cm
• Weight: approx. 122 g
• Oil flow rate, adjustability, individual component dimensions and any cross-reference number: not published by the supplier

What's in the box

• 1 x oil pump
• 1 x worm gear
• 1 x needle bearing
• 1 x washer
• 3 x black accessories, not described further by the supplier
• 1 x gold accessory, not described further by the supplier

Before you fit this kit

• No part number appears anywhere in the listing, so the seven model names and the 7 x 4 cm hole spacing are the only checks available. Compare both against your saw and against the photographs.
• An aftermarket kit. The source stops short of calling it genuine, and Husqvarna is named here purely so buyers can find the right saw.
• Four of the pieces are listed only as black and gold accessories with no description attached. Get in touch first if you need one of those unnamed pieces specifically.
• Drain or plug the oil tank before opening the clutch side, and pull the plug lead before the saw goes on the bench.

Confirm the model and the hole spacing, and this becomes a bench afternoon rather than a new saw.

Returns, Refunds and Replacements

Products received faulty, damaged, or not as described are eligible for a return, refund, or replacement in accordance with local consumer laws. We are committed to ensuring all products meet the standards of quality and reliability expected by our customers. Please note that we do not accept returns or provide refunds for change of mind. We encourage you to carefully consider your purchase to ensure it meets your needs and expectations.