2 Inch Fuel Tank Strap Isolator 6 Feet Length Gas Tank Seal Strap Insulator Rubber for Most Semi Trucks

A steel strap clamped straight onto a fuel tank chafes. Vibration works the strap against the tank wall day after day, the coating goes first and then the metal underneath it. A rubber isolator between the two takes that movement instead of the tank taking it.

Six feet of it, cut to your straps

The strip arrives as one continuous length rather than pre-cut pieces, and the supplier describes the rubber as easy to cut, so it is measured and trimmed to each strap on the vehicle. The title gives 2 inches wide by 6 feet long. The supplier's metric figures are 5.7 cm by 1.85 m, which do not convert exactly from those imperial ones. Both sets appear here as published, unaltered. Measure the actual width of the strap you are lining before ordering, rather than working from either figure on its own.

What it is, and what it is not

This is an isolator: a wear and vibration barrier that sits between strap and tank. Despite the word "seal" appearing in the product title, it is not a sealing component for fuel and it does not retain fuel. Nothing in the supplier data describes it as fuel resistant, and no compound, temperature range or service life is given. The stated application is semi trucks, meaning prime movers and heavy vehicles with saddle tanks. That is the only application the supplier names, and nothing broader is claimed here.

Key features

• Continuous 6 foot length: one piece, cut to suit however many straps you have.
• 2 inch nominal width: sized to sit under a standard tank strap.
• Cuttable with a knife: the supplier's stated design intent, not a workaround.
• Heavy-duty rubber: the material named, chosen to absorb strap movement.
• Barrier between strap and tank: the chafe takes the rubber rather than the tank wall.

Specifications

• Width: 2 inches per the title; 5.7 cm per the supplier
• Length: 6 feet per the title; 1.85 m per the supplier
• Thickness: not published
• Material: heavy-duty rubber; compound not specified
• Fuel and temperature resistance: not published
• Stated application: semi trucks
• Quantity: one length

Before this goes anywhere near a fuel tank

• Tank straps are what hold a full fuel tank onto a vehicle. Adding or changing material under a strap changes how that strap tensions and how it must be tightened, so work to the vehicle or tank manufacturer's specification and re-check the straps after the first run.
• A fuel tank and its lines hold pressure and vapour, and fuel work is a fire risk. Loosening straps on a tank with fuel in it should only be done with the tank properly supported and by someone equipped for the job.
• No fuel resistance, temperature or ageing data is published for this rubber. If it will sit where diesel or petrol runs down the tank wall, confirm compatibility with the supplier first.
• Selecting the material and making the installation safe are the installer's responsibility, not the seller's.

Sold as a single length, ready to be cut down to the straps you already have.

Returns, Refunds, and Replacements

Products that are received faulty, damaged, or not as described are eligible for a return, refund, or replacement in accordance with the Australian Consumer Law (ACL). We are committed to ensuring all products meet the standards of quality and reliability expected by our customers. However, please note that we do not accept returns or provide refunds for change of mind. We encourage you to carefully consider your purchase to ensure it meets your needs and expectations.

Delivery Timeframe

Please note that we cannot guarantee the exact date of arrival, and the delivery timeframes (excluding weekends and public holidays) are as follows:

For customers in Victoria, approximately 7-10 working days;
For customers in NSW, SA, ACT, and QLD, approximately 9-12 working days;
For customers in WA, NT, and TAS, approximately 9-12 working days.