5PCS 10 Gauge 2 Pin Quick Disconnect Polarized Wire Harness, 12 Inch SAE Connector Bullet Lead Cable, Automotive Heavy Duty Extension Cable for Car Motorcycle Boat Tractor (10 AWG)

Anyone who has run a battery charger out to a vehicle knows the fiddle: bonnet up, clips onto terminals, clips knocked off, repeat. A permanently fitted SAE lead ends that. Plug in, charge, unplug. This pack is five two-pin quick-disconnect leads in 10 gauge wire, made for that pattern of use.

What the 55 A figure actually refers to

Read this one precisely. The supplier states that 10 gauge wire suits high current applications and gives 55 A in that context. It does not publish a current rating for these assemblies, and none has been inferred here from the gauge. Nothing is published about a voltage rating, a temperature class, or any standard the connector is built to. What is stated is the physical build: copper conductor, a bullet-header SAE connector described as mating without a gap, and a length the title gives as 12 inch. Polarity is marked the usual way, red to positive and black to negative.

Where the supplier says these get used

The listed applications are battery chargers and trickle chargers, solar panels, and low-voltage high-current outdoor lighting, on cars, motorbikes, trucks, boats, tractors and mowers. That is the supplier's list and it is reproduced rather than extended. No winch application is named anywhere. The supplier describes the wire as waterproof and moisture proof but publishes no IP rating, so treat that as a general description of the jacket rather than a sealing specification.

Before you wire these in

• No fuse, circuit breaker or inline protection is included, and none is mentioned in the supplier's data. Circuit protection is the installer's responsibility.
• Conductor sizing is also the installer's job. The correct gauge depends on your current, your run length and your acceptable volt drop, not on what a lead happens to be made from.
• No wiring instructions beyond the stated polarity are given here, because the supplier gives none. Have 12 V work done by someone competent if you are unsure.
• Check your existing charger or battery plug type against the photos before ordering. SAE two-pin connectors are not all the same.

Key features

• Five leads per pack: one on each vehicle plus a spare on the charger end.
• 10 AWG conductor: the gauge stated for the wire.
• Bullet-header SAE connector: described by the supplier as mating with no gap.
• Polarised two-pin: the connector can only go together one way round.
• Copper conductor: the material named in the supplier's data.

Specifications

• Quantity: 5 pieces
• Wire gauge: 10 AWG
• Length: 12 inch, per the product title; the supplier's description text says approximately 12.99 inches
• Conductor: copper
• Connector: 2-pin polarised SAE, bullet header
• Current rating for the assembly: not published; 55 A appears in the supplier's text as a property of 10 gauge wire in high current use
• Voltage rating, fusing and IP rating: none published

Check the plug on your charger against the photographs before ordering, since that is what has to match.

Returns, Refunds, and Replacements

Products that are received faulty, damaged, or not as described are eligible for a return, refund, or replacement in accordance with the Australian Consumer Law (ACL). We are committed to ensuring all products meet the standards of quality and reliability expected by our customers. However, please note that we do not accept returns or provide refunds for change of mind. We encourage you to carefully consider your purchase to ensure it meets your needs and expectations.

Delivery Timeframe

Please note that we cannot guarantee the exact date of arrival, and the delivery timeframes (excluding weekends and public holidays) are as follows:

For customers in Victoria, approximately 7-10 working days;
For customers in NSW, SA, ACT, and QLD, approximately 9-12 working days;
For customers in WA, NT, and TAS, approximately 9-12 working days.