Car LED Interior Strip Light 3m USB Neon Wire Lamps Glowing Ambient Lighting Car Decorations Interior Red

Footwells and door pockets are black holes after dark, and the cabin light is too harsh to leave on while driving. This 3 m glowing wire runs off a USB port and tucks into the trim gaps around the dash, console and doors.

Three metres, cut to the run you need

The wire ships as one continuous 3 m length with a 5 mm sewn edge, and the supplier says it can be cut shorter to suit each run, with the caveat that a fresh cut end has to be sealed. Its flexibility does the rest: it follows the curve of a dash top or a door card and pushes into the seam so only the glow shows. The supplier describes it as waterproof and very low heat in use, and thin enough to sit in gaps that get touched.

Running off a USB port

Power comes through a USB plug at 5 V with a fuse built into the lead, so there is no cutting into the vehicle's loom and no accessory circuit to chase. Any socket that carries current will run it, whether that is a factory port, a 12 V adaptor or a power bank away from the car. The supplier does note a faint buzzing from the driver when your ear is close, which is normal for wire of this type.

Key features

• 3 m continuous length: enough for a dash run plus both front doors on most cabins.
• Cuttable: trim to length, then seal the new end.
• 5 V USB power: plugs into an existing socket, with a fuse in the lead.
• Red output: a single fixed colour, not a colour-changing strip.

Specifications

• Length: 3 m
• Edge width: 5 mm
• Operating voltage: 5 V DC
• Power source: USB, fused lead
• Colour: red
• Technology: the title describes it as LED; the supplier's own text describes electroluminescent (EL) wire
• Ingress rating: not published; the supplier states only "waterproof"
• Brightness: not published

Before you fit these

• Colour restrictions apply to lighting visible from outside the vehicle while driving, and they vary by state. Confirm the requirements that apply to your vehicle and state before fitting for road use.
• Route the wire clear of the pedals, the steering column, airbag covers and anything else that moves.
• Seal any cut end before powering it back up.

An inexpensive way to finish a cabin at night without touching the vehicle's wiring.

Returns, Refunds and Replacements

Products that are received faulty, damaged, or not as described are eligible for a return, refund, or replacement in accordance with the Australian Consumer Law (ACL). We are committed to ensuring all products meet the standards of quality and reliability expected by our customers. However, please note that we do not accept returns or provide refunds for change of mind. We encourage you to carefully consider your purchase to ensure it meets your needs and expectations.

Delivery Timeframe

Please note that we cannot guarantee the exact date of arrival, and the delivery timeframes (excluding weekends and public holidays) are as follows:

• For customers in Victoria, approximately 7-10 working days;
• For customers in NSW, SA, ACT, and QLD, approximately 9-12 working days;
• For customers in WA, NT, and TAS, approximately 9-12 working days.